Stratospheric solar array
This page contains rough and early details of a concept that I have been brewing recently that seems to have enormous potential the more I think about it.
The basic concept is to have a vast constellation of hydrogen blimps floating in the stratosphere collecting the sun's energy and transmitting it down to a base station at sea.
Contents
Advantages of being in the stratosphere
- In permanent sunshine
- Above most of the weather
- Out of the way of air traffic and wildlife
- The hours of sunshine are extended due to the altitude
- Less attenuation of sunlight due to being above 2/3 of the atmosphere
- Does not take up any land space
If the array is far out in the ocean then there is no shadow being cast where people live and no-one will be able to see it. Even where there is shadow it will be no different to shadow from cloud except that it will be more fragmented due to the spacing of the blimps.
Parabolic solar receivers
Photovoltaic cells are still very expensive, especially ones with high efficiencies (>20%). It may be better to use parabolic reflectors aiming the light onto a thermal receivers. These have been developed at Sandia National Laboratories in the US, the EU's SolAir project and by companies such as Stirling Energy Systems and Infinia.
Stirling Energy Systems state that using their system "a solar farm 100 miles by 100 miles could satisfy 100% of the America’s annual electrical needs".
All the current solar thermal collectors designs would be far too heavy to carry on a blimp, but I outline possible lightweight versions below.
Blimp configuration
There might be a number of ways of achieving this:
1) Large blimps have rows of parabolic reflectors + stirling engines along the top surface. It may be possible to make very lightweight parabolic dishes using aluminised mylar sheets strung in panels across a lightweight frame (or curved inflated ribs on the back surface) or alternatively an inflatable spheroid with one half being a transparent material and the other half being reflective on the inside surface - internal pressure and the shape of the surface material could give the correct parabolic shape. Blimps would have to have counterweights underneath to compensate for the weight on the top surface - propeller units for the blimp might be enough.
2) Blimps carry just the parabolic reflectors underneath which point at a separate receiving station perhaps held by a much larger blimp which receives energy from many reflectors. Blimps would be in herds comprising of many reflector carriers and a mothership.
3) The envelopes of the blimps themselves could be the inflatable spheroid dishes mentioned towards the end of option 1 above. Weights with adjustable positioning are hung underneath to adjust the angle of the reflective surface inside the envelope so as to point in the right direction. Blimps could simply be reflectors pointing at a receiving blimp or each blimp has stirling engine at their focal point. If there are significant aerodynamic issues of having a flattened spheroid angled at the sun, the blimp could instead be spherical and clear with a parabolic reflector held inside.
Station keeping
- Could be tethered to ground with ultrafine, ultra strong fibre. Probably not desirable as get in the way of trans-ocean traffic and vulnerable to storms
- Divert some of the received energy to power ducted propellers or other kind of thruster and virtually anchor using GPS positioning
- Stay in same general region by varying altitude to take advantage of different wind directions at different altitudes similar to the way hot air balloons can have some control of their direction of travel.
- Tug blimps with lateral booms gently pulling a number of carriers
Energy transfer
From sky to sea
- Depends on configuration of collectors. Cables connecting each blimp receiving direct solar energy, then mothership blimps carrying high voltage cable down to floating ground station.
- Or use principle from solar power satellite and generate relatively low energy density microwave beam directed at a floating rectenna
From sea to land
- Undersea cable back to land
- Or use energy to split seawater (salty and good for electrolysis) and gather the hydrogen. Hydrogen then either highly compressed, absorbed in a metal hydride or liquefied is transported by tanker or pipeline to land to help power hydrogen economy.
Potential issues
- Energy cost of station keeping
- Aiming the reflectors accurately at the thermal receivers
- Having a system that reliably keeps focal points of reflectors away from blimp envelope
- Cable or microwave beam hazard depending on method of final energy transfer. Cable could be made radar reflective. Beam could be of low enough energy density to be harmless to passing people and creatures. Beam can also turn off autonomously based on radar if necessary.
- Creating blimps capable of stratospheric altitude while carrying necessary payload
- Creating lightweight parabolic reflectors with accurate enough surfaces to focus sunlight efficiently
Other thoughts
- If sea-based recieving station generates hydrogen as fuel, it could of course also be used for filling the blimp envelopes.
- Envelopes of blimps could be biopolymer films grown in moulds, using nutrients in sea or perhaps CO2 and water to create hydrocarbon raw material. This also might mean that blimps are biodegradable.
- The 'cost' and complexity may make this concept not seem economically viable today, however if the whole scheme was designed to employ closed-loop automation principles so once it has been commissioned it could use the resources of the sea (and perhaps the sea-bed) to create what it needs to run continuously, with little or no human intervention, and if the design of the energy plant (and the autonomous maintenance systems) is done by people using open collaborative design then that might mean a project of this scale become possible. Feasibility fundamentally is a matter of material, energy and intelligence in situations like this - not our current notions of economics.
